![]() Select this check box to print a line on the roll paper between pages in a multi-page document to indicate where the paper should be cut. This feature is only available when Not Cut and Banner Mode are selected, and not available when cutting with the cutter. When this check box is selected, the blank portion of the last page of your document is not fed through the printer. Select this check box when you want to save roll paper. When this check box is selected, the Print page frame check box is enabled. Select this mode when you want to print multi-page data as individual pages, rather than as continuous data. When this check box is selected, the Save Roll Paper check box is enabled. Select this mode when you want to print multi-page data as continuous data on the roll paper, rather than as individual pages. The Roll Paper Option settings are as follows: Make the Roll Paper Option settings at the bottom of the dialog box. Refer to the Printer driver settings with Automatic Roll Paper Cutter and make the setting. If Auto Cut is not available even when Roll Paper is selected as the Paper Source, the Auto Cutter Attached setting has not been made in the printer driver. Auto Cut is selectable after the cutter is attached and Roll Paper is selected as the Paper Source setting.Refer to the Cutting position adjustment with Automatic Roll Paper Cutter for more details about the cutting position adjustment. Use the cutter after you attach it and adjust the cutting position. ![]() Double Cut is selectable only when printing with No Margins selected. By cutting twice, an 18 mm slip of paper is left. In this mode, the space between images is extended and the paper is cut twice inside this space. If you have selected Single Cut and are unhappy with the gap of the cutting position, select Double Cut. However, the cutting position may shift slightly. ![]() The paper is cut at the boundary between images (the boundary between pages). Select the types of cutting from the Auto Cut list box. The remaining paper is ejected the types of cutting from the Auto Cut list box. Cut off the paper at the back of the printer, then turn off the printer. Wait until the printer stops printing and feeding paper. If you have already started printing, cancel the print job from the printer software referring to Cancelling Printing. Doing so causes unnecessary paper to be fed after each print job. In many applications, you can select Print directly from the File menu, then access the printer software by clicking the Properties button.Ĭlick the Paper tab, select Roll Paper for Paper Source, and select the appropriate page size.ĭo not select Sheet Feeder as the Paper Source setting in the printer software when roll paper is loaded in the sheet feeder. Open the file you want to print in the appropriate application.Īccess the printer software from within the application.įor details on accessing the software, refer to the application's user manual. You also cannot select Maximum or Centered as the Printable Area setting, or use the functions on the Layout menu.ĭo not select PhotoEnhance in the printer software, as this may cause your printout to have gaps.Īfter the roll paper is loaded in the printer, follow the steps below to configure your printer software for printing. When printing on roll paper, you cannot use the Reverse Order or Rotate by 180° features. The steps from the printer driver settings to cutting are as follows. The following describes how to print on the roll paper using the cutter. ![]() How To / Using Automatic Roll Paper Cutter
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |